![]() Repeat Steps 2 through 4 for the second strip. ![]() Then, continue adding nails along the strip at consistent intervals. Tap a nail partway in the center of the weatherstripping. Working with weatherstripping without any holes? Simply add the nails through the first and last dots. Visually inspect that the strip appears to be straight, and adjust if necessary. ![]() If your metal weatherstripping with pre-punched holes, slightly drive in a nail in the first hole (at the top) and the last (at the bottom) of the strip, neither all the way in. Hang your first cut of weatherstripping along the door jamb from which the door hangs so that the material nearly touches the threshold. Use tin snips to trim metal away that may impede the operation of hinges. For the top piece, you may even want to pre-punch manually: Place the tip of the awl at each mark and tap with the end of a hammer. If your spring metal weatherstripping does not feature pre-punched holes, dot along the lip of the metal every 1-1/4 inches so that you know where to place your nails. Then, cut the spring metal weatherstripping using tin snips to the appropriate length. Unroll your metal weatherstripping and use a marker to identify your cuts based on the dimensions taken. It’s especially ideal around doors that face the outside, which needs to be reliable enough to seal out water and bugs.Īfter any previous existing weatherstripping has been removed, measure the width of the door frame and the length of the door jamb (the vertical parts of the frame, one of which the door hangs on). This type of weatherstripping performs the same task as your average vinyl or foam stick-on weatherstripping, but can do so better and for longer-up to 30 years. Method 1: Seal the Door with Spring-Metal StripsĬreate a better door seal and prevent noise from penetrating through the cracks by installing new spring bronze weatherstripping. Determine your needs for the space-whether that’s just enough quiet to fall asleep or complete silence for your basement recording studio-and get to work with one of these three methods.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |